Wall Mount 2 Pressure 0 - 60 PSI CO2 regulator with 1/4 Barb fittings and ball valve shutoffs
and 60" high pressure line
This commercial
quality, 2 pressure, triple gauge regulator is built to last and loaded with commercial grade
features! It works with any Co2 Tank with a CGA-320 valve, the USA and Canadian
standard, and measures PSI. The high pressure gauge measures 0 � 2000 PSI, indicates
how much Co2 is left in the cylinder and when it should be refilled. The
adjustment screws in the center is used to easily adjust the output pressure and
can be adjusted with a thin dime or a small screwdriver. The adjustment screw
also features a locking nut to prevent tampering.
The commercial
2 pressure, triple
gauge
Co2 regulator has a forged brass body. This regulator also features a
non-adjustable safety blow off at 60 PSI, a flow control inlet nipple filter and
a re-useable nylon CO2 tank inlet seal. Also included is a check valve in the
outlet that prevents backflow of liquids into the regulator. In addition, the
flow control on this regulator is automatic, which means that it automatically
adjusts and regulates the pressure. This is the industry standard found in most
commercial environments.
This CO2 regulator set comes complete with:
2 independent regulators with individual, settable pressures
2 - 0 - 60 PSI low pressure gauges
0 - 2000 PSI tank pressure gauge
Ball valve shutoff valve with integral check valve on each regulator
Re-useable nylon CO2 tank seal
Pre-attached wall mount brackets
60" flexible high pressure line
This regulator measures:
10.2" Wide (end of gauge to where the high pressure line
can flex)
6.75" tall (top of gauge to tip of red shutoff valve)
4.24" deep (bottom of mounting bracket to top of silver
adjustment screw)
The hose is flexible enough to bend into a 6" circle (3" radius) if needed.
Australian Orders - Unless you instruct
us to do otherwise, all regulators shipped from us have the correct AS2473 Type
30 Australian tank nut already installed.
European Orders - Unless you instruct us to do otherwise, all regulators
shipped from us have a European DIN 477 No. 6 tank nut already installed. This
tank nut should be compatible throughout Europe and England - please verify with
your local CO2 supplier before ordering from us.
